Change The Drive Belt On A Harleydavidson

Change the Drive Belt on a Harley-Davidson

The Harley-Davidson drive belt is what feeds the rear wheel power from the transmission. Harley drive belts are very strong and durable and only need replacement after thousands of miles of riding. Unless you have a warranty, a replacement will cost a few hundred dollars at your Harley dealer. Do it yourself in about 30 minutes, for less than $50.

Instructions

1. Place the Harley onto a motorcycle stand to get the rear wheel off the ground. Use a wrench to remove the rear wheel axle. Push the rear wheel forward to give slack to the drive belt.

2. Remove the belt guards with the ratchet set. Pull the drive belt off the transmission sprocket and rear wheel sprocket.

3. Place the new drive belt on the transmission and rear wheel sprocket. Pull the rear wheel back toward the rear end of the Harley to tighten the new drive belt. Replace the rear wheel axle and tighten sightly.

4. Tighten the new drive belt according to the specifications for your Harley model. Reconnect the belt guards. Use an alignment tool on the rear tire according to the owner’s manual.